2BChapter 3: Camera configuration
TruVision IP PTZ Camera Configuration Manual 33
7. Select the day and click to set the start and end time periods. You can
copy the schedule to other days or to the whole week.
8. Click OK to save changes.
9. Specify the linkage method when an event occurs. Check one or more
response methods for the system when a motion detection alarm is triggered.
Alarm Host Send an exception or alarm signal to remote management
software when an event occurs.
Email Sends an email to a s
pecified address when there is a motion
Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Channel Triggers the recording to start in the camera.
Trigger external alarm outputs when an event occurs.
Note: This option is only supported by cameras that support
alarm output.
10. Click Save to save changes.
Tamper-proof alarms
You can configure the camera to trigger an alarm when the lens is covered and
to take an alarm response action.
To set up tamper-proof alarms:
1. In the Events folder (1), click the Tamper-proof tab (2) to open its window.
To Next Page
Loading...
Need help?
General
