2BChapter 3: Camera configuration
30 TruVision IP PTZ Camera Configuration Manual
To add privacy mask area:
1. In the PTZ folder (1), click the Privacy Mask tab (2) to open its window.
2. Check the Enable Privacy Mask (3).
3. Click the PTZ control buttons to point the camera at the area where you want
to set the privacy mask. Click Draw Area (4).
4. Click and drag the mouse in the live video window to draw the mask area.
5. Click Stop Drawing to finish drawing, or click Clear All to clear all of the
areas you set without saving them.
6. Click Add (5) to add the area. Enter its name, color, and active zoom ratio.
Each mask can be individually set.
Note: The active zoom ratio is the magnification level the camera will zoom
into when motion is detected.
7. Click Save to save changes.
To Next Page
Loading...
