Interlogix xGenConnect NXG-4 - Page 125

xGenConnect Installation and Programming Guide 113
If no schedule is set (or is currently active) in either the first or second zone
profile then the zone will be disabled.
See the next section for programming custom zones.
Programming Sequence
7. Schedules
15. Zone Types
16. Zone options
→
- Area Armed
→
→
- Area disarmed
14. Holidays
3. Zones
4. Areas
12. Area Groups
a) Profile 1
→
a) Area Options
→
b) Profile 2
b) Area Timers
c) Area Reporting
15. Zone Type
7. Schedule
16. Zone Options
18. Channel Groups
12. Area Group
7. Schedule
1. User
Instructions
1. Go to Zones.
2. Select a zone number you want to program.
3. Enter a name for the zone.
4. Select a zone type preset.
5. Select a zone options preset.
6. Select an Area group for the zone. If you want a zone to be in its own Area
then select an Area group with only one Area. To create a zone in a common