114 xGenConnect Installation and Programming Guide
Area, select an Area group with multiple Areas. Alternatively come back to
this step later.
7. For a standard installation set the schedule to a preset which is 24 hours
every day, holidays should NOT be ticked in this schedule. This will enable
the first zone profile.
If you want the zone settings to change based on a schedule, then select the
first schedule here.
8. If you are setting up a keyswitch zone then the user number field controls
which user profile will be used to arm/disarm. The keyswitch zone will report
as default User 99.
9. If you are programming a second zone profile, then go to that now and repeat
steps 4 to 7.
Web Page
To Next Page
Loading...
