154 xGenConnect Installation and Programming Guide
Zone Number. Zone Name
• In alarm: This zone has triggered a system alarm condition.
• Is bypassed: This zone is bypassed (inhibited) and will not activate an alarm.
• Chime is set: This zone is part of the chime group.
• Is not secure: This zone is not closed.
• Fire alarm: This zone has triggered a fire alarm.
• Tamper: This zone has triggered a tamper alarm.
• Trouble fault: This zone has an open circuit.
• Loss of wireless supervision: This zone is a wireless device and has lost its
communication link with the control panel. Check the zone is within range of
the panel and has sufficient battery.
• Low battery: This zone is a wireless device and needs a battery replacement.
To Next Page
Loading...
