Chapter 1 — Using the Computer
20 CK3 Mobile Computer User’s Manual
3 Press the Scan button or pull the trigger on your scan handle. The
laser pointer and illumination beam and frame appear.
4 Use the laser pointer as a guide and aim toward the middle of the
bar code. Make sure that the illumination frame covers the bar
code you are trying to decode.
When the CK3 successfully reads a bar code label, you hear a high
beep, and the Good Read LED turns on briefly.
5 Release the Scan button or trigger.
Scanning With the Near-Far Range Area Imager
1 Press to turn on the CK3.
2 Point the scanner window at the bar code label.
3 Press the Scan button or pull the trigger. The illumination beam
and laser pointer appear.
• For near or close-in scanning distances of 30 cm (11.8 in) or
less, use the laser pointer as a guide and aim slightly to the
right of the center of the bar code. Make sure the illumination
beam covers the bar code you are trying to decode.
To Next Page
Loading...
Need help?
General
