Chapter 2 — Connecting and Configuring the CK3
38 CK3 Mobile Computer User’s Manual
2 Follow the onscreen instructions to connect to a Bluetooth audio
device.
Configuring Ethernet Communications
You connect your CK3 to your Ethernet network with an Ethernet
cable and one of these accessories:
• AD20 single dock with an AA12 Ethernet adapter
• AD21 Ethernet multidock
To use your CK3 in an Ethernet network
1 Connect your CK3 to an Ethernet network with an AD20 or AD21.
Ethernet communications is automatically enabled on your CK3.
2 Configure these network parameters:
• If you have a DHCP server, enable DHCP.
• If you do not have a DHCP server, set these parameters:
a IP address
b Subnet mask
c Default router
3 If necessary, set these parameters:
• Primary and secondary DNS servers
• Primary and secondary WINS servers
To Next Page
Loading...
Need help?
General
