Chapter 1 — Using the Computer
CK3 Mobile Computer User’s Manual 21
• For standard and long range scanning distances of 30 cm
(11.8 in) or more, use the laser pointer as a guide and aim
toward the middle of the bar code. Make sure that the
illumination beam covers the bar code you are trying to
decode.
When the CK3 successfully reads a bar code label, you hear a high
beep, and the Good Read LED turns on briefly.
4 Release the Scan button or trigger.
Improving the Performance of the Area Imager
If you experience problems scanning a bar code with the 2D imager,
try these possible solutions.
• Keep your hand as steady as possible while scanning a label.
• Position the imager as close to the bar code as possible while still
being able to capture the entire bar code.
• Enable only the bar codes that you need to use every day.
• Choose a Predefined mode in Intermec Settings:
a Tap Start > Settings > the System tab > Intermec Settings.
b Tap Data Collection > Internal Scanner > Imager Settings >
Predefined Modes and then select one of these options:
Predefined Mode Select if You Are Scanning:
1D Only 1D labels.
1D and 2D
Standard
All types of bar code labels.
1D and 2D Bright
Environment
In high ambient light, such as outdoors in the
sunshine.
1D and 2D
Reflective Surface
Glossy labels.
Custom In conditions that require customized settings.
For more information about these settings,
commands, and parameters, see the Intermec
Settings Command Reference Manual available
from the Intermec web site at
www.intermec.com.
To Next Page
Loading...
Need help?
General
