Chapter 1 — Using the Computer
22 CK3 Mobile Computer User’s Manual
• If you are scanning multiple bar codes in a small area, use one of
these parameters:
• Aiming beam activation
• Aim triggering mode
• Center decoding
To enable these parameters, use Intermec Settings. For help, see
“Using Intermec Settings Directly On the CK3” on page 31.
For help scanning using center decoding, see the next procedure.
To scan a bar code using center-decoding
1 Press to turn on the CK3.
2 Point the scanner window at the bar code label.
3 Press the Scan button or pull the trigger. The illumination beam
and the laser pointer appear.
4 Aim both the illumination beam and the laser pointer at the bar
code you want to scan.
Note: The center-decoding parameter only decodes a bar code if
the laser pointer is on the bar code and the illumination beam
covers the bar code.
To Next Page
Loading...
Need help?
General
