Chapter 2 — Connecting and Configuring the CK3
CK3 Mobile Computer User’s Manual 33
Configuring the CK3 Remotely With SmartSystems
Foundation
Intermec’s SmartSystems Foundation lets you manage all of your
SmartSystems-enabled devices simultaneously from a central
location. The SmartSystems console displays all of the SmartSystems-
enabled devices in your network.
Your CK3 is SmartSystems-enabled, which lets you open Intermec
Settings from the SmartSystems console to remotely configure all of
your CK3 computers.
To open Intermec Settings from the SmartSystems console
1 In the SmartSystems console, right-click a CK3.
2 Select Intermec Settings.
For more information about SmartSystems Foundation, go to the
Intermec web site at www.intermec.com/products/
smrtsysfoundation/index.aspx.
Configuring the CK3 for Your Network
The CK3 is a versatile mobile computer that you can easily add to
your wireless or wired data collection network. You can connect your
CK3 using:
• 802.11b/g or 802.11a/b/g radio communications.
• Bluetooth communications.
• Ethernet communications
• USB and serial communications.
Configuring 802.11 Radio Communications
Your CK3 has an 802.11b/g or 802.11a/b/g radio to transfer data
using wireless communications. This section assumes that your
wireless network is set up, including your access points.
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.
To Next Page
Loading...
Need help?
General
