Chapter 2 — Connecting and Configuring the CK3
42 CK3 Mobile Computer User’s Manual
Configuring WPA Security With Funk Security
Use these procedures to set WPA-802.1x, WPA2-802.1x, WPA-PSK, or
WPA2-PSK security on your CK3 with Funk security.
To configure WPA-802.1x or WPA2-802.1x with Funk security
1 Make sure the communications and radio parameters on your
CK3 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose WPA or WPA2. Encryption
automatically defaults to TKIP or AES, respectively.
7 For 8021x, choose TTLS, PEAP, EAP-FAST, or TLS and press
Enter.
8 If you choose TTLS or PEAP:
a For Prompt for Credentials, choose Enter credentials now.
b Tap User Name, enter your user name, and press Enter.
c Tap User Password, enter your password, and press Enter.
d For Validate Server Certificate, choose Yes and press Enter.
If you choose TLS:
a Load a user and root certificate on your CK3. For help, see
“Loading a Certificate” on page 49.
b Enter a User Name and Subject Name.
c For Validate Server Certificate, choose Yes and press Enter.
Note: You can use Prompt for Credentials to troubleshoot
your network connection.
Note: The correct date must be set on your CK3 when you
enable Validate Server Certificate.
To Next Page
Loading...
Need help?
General
