Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 5
Replacing the Radome (Top Cover)
There are two spared parts on the CV30 radome or top cover. You can
replace the entire top cover assembly or you can just replace the radome
daughter board PCB. To replace the top cover or the radome PCB, you
need these parts and tools.
To replace the radome assembly or radome PCB
1 Open the top cover. For help, see “Opening the Top Cover (Radome)”
on page 2.
2 If you need to replace the radome daughter board PCB:
a Remove the two Phillips screws that attach the board to the radome
assembly.
b Remove the daughter board from the radome cover.
Parts and Tools
Description Part Number
CV30 radome assembly VE011-S6015-xx
CV30 radome PCB VE011-6011-xx
Small Phillips screwdriver
Antenna cable remover 591802-001
To Next Page
Loading...
