Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 31
2 Make sure the server and the CV30s are on the same subnet.
3 Make sure your CV30s have power management disabled.
4 Download the device upgrade .exe file to your desktop PC.
5 Double-click the .exe file on your desktop PC. An InstallShield
application starts and walks you through the process of extracting the
upgrade files in the default location.
6 In the software vault, locate the device upgrade you want to install.
7 Drag-and-drop the device upgrade onto each CV30 you want to reflash.
SmartSystems server will tell you that it is installing the upgrade on your
CV30.
Once the upgrade is done downloading to your CV30, your CV30 loads
the operating system and then automatically cold boots. Progress messages
appear on the CV30 screen.
The SmartSystems server will show the CV30 as being offline until the
CV30 reboots and reconnects to the system.
Clean Booting the CV30
When you clean boot the CV30, it loads only those files and programs that
are absolutely required by the operating system. Use the clean boot to
troubleshoot the computer by getting it up and running so that you can
perform diagnostic tests to determine which elements of the normal boot
process are causing problems.
To clean boot the CV30
1 Using a small pointed device (such as the end of the stylus) or your
finger, press the Reset switch on the top of the CV30 at the same time as
you press the Power button.
Note: Do not change the default location where InstallShield extracts the
files. SmartSystems server requires that the files be located in the default
directory.
Do not use force or a sharp object when pressing the reset switch.
You may damage the reset switch.
Vorsicht: Keine Gewalt anwenden oder scharfe Gegenstände
verwenden, um die Rücksetztaste zu drücken. Das könnte die
Rücksetztaste beschädigen.
To Next Page
Loading...
