Intermec CV30 - Replacing the Inverter Board

Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 13
9 Insert the touch panel assembly and connect the two flex cables to the
CV30.
10 Replace the front cover and secure it with the six 4-40 x 5/8 inch screws
and the two 4-40 x 3/8 inch screws removed previously and tighten to
.73 Nm (6.5 lb-in).
11 Reattach the antenna cable to the Remote Antenna connector on the
radome board assembly PCB.
12 Replace the top cover and secure it with the six 4-40 x 3/8 inch Phillips
screws removed previously and tighten to .62 Nm (5.5 lb-in).
13 Reconnect power to the CV30.
Replacing the Inverter Board
To replace the inverter board, you need these parts and tools.
To replace the inverter board
1 Open the top cover. For help, see “Opening the Top Cover (Radome)”
on page 2.
2 Open the front cover. For help, see “Opening the Front Cover” on
page 4.
3 Use the flathead screwdriver to release the two flex connectors that
connect the touch panel to the CV30.
Parts and Tools
Description Part Number
Inverter Board PCB VE011-6006-xx
Inverter harness VE011-8057-xx
Small Phillips screwdriver
Antenna cable remover 591802-001
Flathead screwdriver
The flex connectors are called zero insertion force (ZIF) connectors
and they are very fragile. To avoid breaking the connectors, open and
close them carefully. Do not apply excessive pressure to the movable
part of the connector when opening and closing it.
Vorsicht: Die Flex-Steckverbinder werden als ZIF-Steckverbinder
(Zero Insertion Force) bezeichnet und sind extrem zerbrechlich. Die
Steckverbinder müssen vorsichtig geöffnet und geschlossen werden,
damit sie nicht beschädigt werden. Beim Öffnen und Schließen
keinen starken Druck auf den beweglichen Teil des Steckverbinders
ausüben.