Intermec CV30 - Replacing the Gasket

Chapter 1 — Replacing Parts
24 CV30 Fixed Mount Computer Service Manual
Replacing the Gasket
To replace the gasket, you need these parts and tools.
To replace the gasket
1 Open the top cover. For help, see “Opening the Top Cover (Radome)”
on page 2.
2 Open the front cover. For help, see “Opening the Front Cover” on
page 4.
3 Use the flathead screwdriver to release the keypad flex connector from
the touch panel assembly and remove the front cover.
4 Using your fingers, lift up on one corner of the gasket and pull up until
the gasket is completely separated from the base assembly.
Parts and Tools
Description Part Number
Rear housing gasket VE011-8017-xx
Antenna cable remover 591802-001
Small Phillips screwdriver
Flathead screwdriver
The flex connectors are called zero insertion force (ZIF) connectors
and they are very fragile. To avoid breaking the connectors, open and
close them carefully. Do not apply excessive pressure to the movable
part of the connector when opening and closing it.
Vorsicht: Die Flex-Steckverbinder werden als ZIF-Steckverbinder
(Zero Insertion Force) bezeichnet und sind extrem zerbrechlich. Die
Steckverbinder müssen vorsichtig geöffnet und geschlossen werden,
damit sie nicht beschädigt werden. Beim Öffnen und Schließen
keinen starken Druck auf den beweglichen Teil des Steckverbinders
ausüben.