Intermec CV30 - Replacing the Touch Panel Assembly

Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 9
9 Connect the two 802.11 radio coaxial cables to the radome board
assembly PCB.
10 Reattach the radome daughter board antenna cable to the Remote
Antenna connector on the radome board assembly PCB.
11 Attach the radome cover and secure it with the six 4-40 x 3/8 inch
Phillips screws removed previously and tighten to 5.5 lb-in.
12 Reconnect power to the CV30.
Replacing the Touch Panel Assembly
To replace the touch panel assembly, you need these parts and tools.
To replace the touch panel assembly
1 Open the top cover. For help, see “Opening the Top Cover (Radome)”
on page 2.
2 Open the front cover. For help, see “Opening the Front Cover” on
page 4.
3 Use the flathead screwdriver to release the two flex connectors that
connect the touch panel to the CV30.
4 Lift the touch panel assembly away from the CV30.
Parts and Tools
Description Part Number
Touch panel service assembly VE011-S6018-xx
Small Phillips screwdriver
Antenna cable remover 591802-001
Flathead screwdriver
Cleaning solution and cloths for
cleaning coated optical glass.
The flex connectors are called zero insertion force (ZIF) connectors
and they are very fragile. To avoid breaking the connectors, open and
close them carefully. Do not apply excessive pressure to the movable
part of the connector when opening and closing it.
Vorsicht: Die Flex-Steckverbinder werden als ZIF-Steckverbinder
(Zero Insertion Force) bezeichnet und sind extrem zerbrechlich. Die
Steckverbinder müssen vorsichtig geöffnet und geschlossen werden,
damit sie nicht beschädigt werden. Beim Öffnen und Schließen
keinen starken Druck auf den beweglichen Teil des Steckverbinders
ausüben.