Chapter 1 — Replacing Parts
8 CV30 Fixed Mount Computer Service Manual
c Attach the two coaxial cables to the new 802.11 radio module. The
longer cable attaches to the middle cable connector on the module.
The shorter cable attaches to the connector closest to the edge.
d Insert the new 802.11 radio module into the CV30.
6 If you need to replace the backup battery:
a Disconnect the backup battery cable from the Main PCB and slide
the backup battery out of the CV30.
b Insert the new backup battery and attach the cable to the Main PCB.
7 Attach the CV30 radome harness to the new radome board assembly
PCB and feed the two 802.11 radio antenna coaxial cable connectors
through the holes in the new radome board assembly PCB.
8 Replace the five 4-40 x 1/4 inch Phillips screws that attach the radome
board assembly PCB to the CV30 frame.
802.11 Radio
Coaxial cables
Backup battery
To Next Page
Loading...
