Intermec CV30 - Replacing the Radome Board Assembly PCB

Chapter 1 — Replacing Parts
6 CV30 Fixed Mount Computer Service Manual
i
c Insert the new daughter board into the radome cover being careful
not to damage the antenna connector.
d Secure the daughter board with two Phillips screws.
3 Reconnect the radome antenna to the remote antenna connector on the
radome board assembly PCB.
4 Attach the new radome cover and secure it with the six 4-40 x 3/8 inch
Phillips screws removed previously and tighten to 5.5 lb-in.
5 Reconnect power to the CV30.
Replacing the Radome Board Assembly PCB
To replace the radome board assembly PCB, you need these parts and tools.
To replace the radome board assembly PCB
1 Open the top cover. For help, see “Opening the Top Cover (Radome)”
on page 2.
2 Disconnect the two 802.11 radio antenna coaxial cables from the
radome board assembly PCB.
3 Remove the five 4-40 x 1/4 inch Phillips screws that attach the radome
board assembly PCB to the CV30 frame.
Radome
assembly
Radome
daughter
board
Parts and Tools
Description Part Number
CV30 radome board assembly PCB VE011-S6026-xx
Small Phillips screwdriver
Antenna cable remover 591802-001