Chapter 1 — Replacing Parts
10 CV30 Fixed Mount Computer Service Manual
5 Make sure the inner surface of the touch panel and the display are dust
free and have no fingerprints before installing the touch screen. Use the
cloth and cleaning solution if you need to clean any surfaces.
6 Insert the new touch panel assembly and connect the two flex cables to
the CV30.
7 Replace the front cover and secure it with the six 4-40 x 5/8 inch screws
and the two 4-40 x 3/8 inch screws removed previously and tighten to
.73 Nm (6.5 lb-in).
8 Reattach the antenna cable to the Remote Antenna connector on the
radome board assembly PCB.
9 Replace the top cover and secure it with the six 4-40 x 3/8 inch Phillips
screws removed previously and tighten to .62 Nm (5.5 lb-in).
10 Reconnect power to the CV30.
Replacing the Display Frame Assembly
To replace the display frame assembly, you need these parts and tools.
Parts and Tools
Description Part Number
Frame display assembly VE011-S6019-xx
Small Phillips screwdriver
Antenna cable remover 591802-001
Flathead screwdriver
To Next Page
Loading...
