Intermec CV30 - Replacing the Keypad

Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 17
Replacing the Keypad
To replace the keypad, you may need these some or all of these parts and
tools.
To replace the keypad
1 Open the top cover. For help, see “Opening the Top Cover (Radome)”
on page 2.
2 Open the front cover. For help, see “Opening the Front Cover” on
page 4.
3 Use the flathead screwdriver to release the keypad flex connector from
the touch panel assembly and remove the front cover.
4 Lay the front cover down on a flat surface with the keypad PCB facing
up.
5 Remove the yellow Kapton tape that covers the back of the speaker and
disconnect the two cables from the keypad PCB.
6 Remove the five Phillips screws that secure the keypad PCB to the front
cover and remove it.
Parts and Tools
Description Part Number
Keypad board PCB VE011-S6005-xx
CV30 keypad VE011-8020-xx
CV30 keypad flex VE011-8052-xx
Small Phillips screwdriver
Antenna cable remover 591802-001
Flathead screwdriver
The flex connectors are called zero insertion force (ZIF) connectors
and they are very fragile. To avoid breaking the connectors, open and
close them carefully. Do not apply excessive pressure to the movable
part of the connector when opening and closing it.
Vorsicht: Die Flex-Steckverbinder werden als ZIF-Steckverbinder
(Zero Insertion Force) bezeichnet und sind extrem zerbrechlich. Die
Steckverbinder müssen vorsichtig geöffnet und geschlossen werden,
damit sie nicht beschädigt werden. Beim Öffnen und Schließen
keinen starken Druck auf den beweglichen Teil des Steckverbinders
ausüben.