Intermec CV30 - Replacing the Touch Heater PCB

Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 19
13 Reattach the antenna cable to the Remote Antenna connector on the
radome board assembly PCB.
14 Replace the top cover and secure it with the six 4-40 x 3/8 inch Phillips
screws removed previously and tighten to .62 Nm (5.5 lb-in).
15 Reconnect power to the CV30.
Replacing the Touch Heater PCB
To replace the touch heater PCB, you need these parts and tools.
To replace the touch heater PCB
1 Open the top cover. For help, see “Opening the Top Cover (Radome)”
on page 2.
2 Open the front cover. For help, see “Opening the Front Cover” on
page 4.
3 Use the flathead screwdriver to release the three flex connectors from the
touch panel assembly and remove the front cover.
4 Remove the four 4-40 x 3/8 inch Phillips screws that attach the display
frame to the CV30 base.
Parts and Tools
Description Part Number
Touch heater board PCB VE011-S6004-xx
Touch heater PCB harness VE011-8055-xx
Small Phillips screwdriver
Flathead screwdriver
The flex connectors are called zero insertion force (ZIF) connectors
and they are very fragile. To avoid breaking the connectors, open and
close them carefully. Do not apply excessive pressure to the movable
part of the connector when opening and closing it.
Vorsicht: Die Flex-Steckverbinder werden als ZIF-Steckverbinder
(Zero Insertion Force) bezeichnet und sind extrem zerbrechlich. Die
Steckverbinder müssen vorsichtig geöffnet und geschlossen werden,
damit sie nicht beschädigt werden. Beim Öffnen und Schließen
keinen starken Druck auf den beweglichen Teil des Steckverbinders
ausüben.