Intermec CV30 - Reflashing the CV30 Using Smartsystems Server

Chapter 1 — Replacing Parts
30 CV30 Fixed Mount Computer Service Manual
7 If you are using an SD card reader, insert the SD card into the CV30.
8 Perform a clean boot on the CV30. For help, see “Clean Booting the
CV30” on page 31.
To upgrade the SSPB files
1 Back up all of the applications and data.
2 Download the latest SSPB (.exe) file from the Intermec web site to your
PC or laptop.
3 Double-click the .exe file on your computer. An installation wizard
starts and walks you through the process of extracting the upgrade files.
The installation wizard extracts the upgrade files to:
C:\Program Files\Intermec\SmartSystem\ss_lib\Software\
<version>
Copy all files in this directory to the SD card. Do not copy the .exe file
to the SD card.
4 If you are using an SD card reader, remove the SD card from the CV30
and place it in the reader.
5 Copy the contents of the <version> folder to the SD card.
6 If you are using an SD card reader, insert the SD card into the CV30.
7 Perform a clean boot on the CV30. For help, see “Clean Booting the
CV30” on page 31.
Reflashing the CV30 Using SmartSystems Server
You can use the SmartSystems server to reflash the operating system on the
CV30. The server is part of SmartSystems Foundation, which is available
from the Intermec web site.
Before you can reflash the CV30, you need:
• SmartSystems Foundation. To download SmartSystems Foundation, go
to www.intermec.com/SmartSystems.
• the device upgrade .exe file. This file is available from the Intermec web
site at www.intermec.com. Go to Service & Support > Downloads.
To reflash a CV30 using SmartSystems Server
1 Install SmartSystems Foundation on your desktop PC and open the
server.
Note: Make sure the CV30 has completely loaded all of the upgrade files
before you remove the SD card or reset the computer.
Note: Make sure the CV30 has completely loaded all of the upgrade files
before you remove the SD card or reset the computer.