Chapter 1 — Replacing Parts
26 CV30 Fixed Mount Computer Service Manual
Replacing the Membrane Vent
To replace the membrane vent, you need these parts and tools.
To replace the membrane vent
1 Unscrew the membrane vent with the socket wrench and remove from
the CV30.
2 Insert the new membrane vent and use the socket wrench to tighten it.
Testing the CV30 With the Test Fixture
After you replace any part of the CV30, you should use the test fixture to
make sure that the CV30 is operating properly. To test the CV30, you
need:
• T46173 test fixture. The test fixture is located at:
\\Usevtnas1\Operations\Records\Public\Test_SW if you are within the
Intermec firewall. If not, contact your local Intermec representative to
get the test fixture.
• Microsoft® ActiveSync® version 4.2 or later
The test system uses program T46174 and ActiveSync to push test fixture
T46173 out to the CV30.
Parts and Tools
Description Part Number
Membrane vent VE012-5006-xx
Six Point Socket wrench
Membrane vent
To Next Page
Loading...
