Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 25
5 Place the new gasket on the CV30 base assembly and starting at one
corner, gently press the gasket onto the base assembly until the gasket is
firmly attached.
6 Reconnect the keypad flex connector to the touch panel assembly.
7 Replace the front cover and secure it with the six 4-40 x 5/8 inch screws
and the two 4-40 x 3/8 inch screws removed previously and tighten to
.73 Nm (6.5 lb-in).
8 Reattach the antenna cable to the Remote Antenna connector on the
radome board assembly PCB.
9 Replace the top cover and secure it withthe six 4-40 x 3/8 inch Phillips
screws removed previously and tighten to .62 Nm (5.5 lb-in).
10 Reconnect power to the CV30.
Gasket
To Next Page
Loading...
