Chapter 1 — Replacing Parts
16 CV30 Fixed Mount Computer Service Manual
9 Insert the new inverter board PCB and secure it to the frame display
assembly with the two Phillips screws removed in the previous step.
10 Reattach the inverter PCB harness and the display harness to the
inverter board PCB.
11 Insert the frame display assembly back into the CV30 base, connect the
display flex cable and the inverter PCB harness, and replace the four 4-
40 x 3/8 inch Phillips screws removed in Step 5.
12 Replace the touch panel assembly and connect the two flex cables to the
CV30.
13 Replace the front cover and secure it with the six 4-40 x 5/8 inch screws
and the two 4-40 x 3/8 inch screws removed previously and tighten to
.73 Nm (6.5 lb-in).
14 Reattach the antenna cable to the Remote Antenna connector on the
radome board assembly PCB.
15 Replace the top cover and secure it with the six 4-40 x 3/8 inch Phillips
screws removed previously and tighten to .62 Nm (5.5 lb-in).
16 Reconnect power to the CV30.
Screw
(2 places)
Inverter board PCB
Inverter harness
To Next Page
Loading...
