Chapter 1 — Replacing Parts
CV30 Fixed Mount Computer Service Manual 7
4 Lift the radome board assembly PCB away from the CV30 carefully and
disconnect the CV30 radome harness. You will also need to carefully
feed the 802.11 radio antenna coaxial cables through the radome board
assembly PCB.
5 If you need to replace the 802.11 radio module:
a Using a needlenose pliers or your fingers, gently pull the 802.11
radio module out of the CV30.
b Disconnect the two coaxial cables from the 802.11 radio module.
Screw
(5 places)
Coaxial cables
Radome PCB
Radome harness
To Next Page
Loading...
