Intermec EasyCoder PD41 Programmer's Guide

ZSim Programmer’s Guide 15
o
Initial Configuration Setup Menu
Input all COM/IP-
Initializing
COM/IP...
Init COM/IP-Para.?
No=F2 Yes=ENTER
Initial Setup
<ENTER> = Start
Load Media!
<ENTER> = Continue
Sim.Resolution:
[203/300/152 (DPI)]
Paper Type:
[Direct Thermal/...]
Print Mode:
[Tear Off/Peel Off/...]
Media Type:
[Non Cont. Gap/Cont/...]
Calibrating
Media ...
Measured Length
4,178 in...
Cancel = F2
Input Port:
[Serial,Parallel/...]
Head Lifted
Head Lowered
Head Lift
F2
F2
Printing Config
Label ...
Save Config?
Redo=F2 Ok=ENTER
Saving Config
.....................
Parameters...
Enter
F2
ZSim X.XX
Serial
F2
Media Length Ok?
No=F2 Yes=ENTER
Change COM/IP?
No=F2 Yes=ENTER
Start Up
READY
ENTER
Ser/Network
Parallel
Waiting Media
Load New Media!

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g