Intermec EasyCoder PD41 Programmer's Guide

32 ZSim Programmer’s Guide
Units
Purpose: The unit of measurement used when entering
the Label Length or Label Width values. You
can set this command to millimeters or inches.
Use Last Saved
Purpose: Sets all of the ZSim program values back to the
last saved configuration. Use Save Current to
save configuration parameters.
X-Offset
Purpose: Positions the printout distance from the left
edge of the label. Range ± 0 to 999 dots.
Default: 0 dots
Y-Offset
Purpose: Positions the printout distance from the front
edge of the label. Range ± 0 to 999 dots.
Default: 0 dots
Entering Parameters
You enter parameters on the printer differently depending on the
printer model.
• Use the numeric keyboard to access the alpha characters on
the PF/PM/PX printers.
• Send a text file from the PD41 and PB50 printers that do not
have keyboards. For help, see “Configuring ZSim Using Text
File Download” on page 16.
Use the following illustrations and sections to understand how to
switch modes and select characters on the PF/PM/PX printers.

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g