Intermec EasyCoder PD41 - Operating the Printer

ZSim Programmer’s Guide 13
Loading ZSim on the Printer with FieldInstaller
The PB50 does not support the use of a CompactFlash card. To
load ZSim on the PB50, you need:
• a serial cable (P/N 075497) to connect the PB50 to your PC.
• the FieldInstaller application.
• the ZSim application.
You can download FieldInstaller and the ZSim application from
the Intermec web site at www.intermec.com. Select Support >
Downloads, and then go to the PB50 printers page.
To load ZSim on the printer with FieldInstaller
1 Connect the PB50 to your desktop PC with the serial cable.
2 Install FieldInstaller on your desktop PC.
3 Extract the ZSim files to your desktop PC.
4 Open FieldInstaller by going to Start > Programs > Intermec
FieldInstaller > Intermec FieldInstaller.
5 In the Introduction page, click Next.
6 In the Select installation package page, select the ZSim
installation package and then click Next.
7 In the License Agreement page, select I agree and then click
Next.
8 In the Connection type page, select Serial and then click
Next.
9 In the Select serial port page, select a communication port
and then click Install.
10 When the Finished! page appears, click Exit.