ZSim Programmer’s Guide 25
Configuration Commands
The following summaries describe each configuration command
and list valid ranges and default values where applicable.
Allow Reverse
Purpose: Allows reverse printing (black background with
white letters) on the label, either for the entire
label (^LR) or for specific fields (^FR).
Default: On
Calibrate
Purpose: Measures the label length and calibrates the
sensors.
Change Caret
Purpose: Changes the format instruction prefix to
another ASCII character.
Default: ^ (ASCII 94)
Change Delimiter
Purpose: Changes the ZPL delimiter character.
Default: , (ASCII 44)
Change Tilde
Purpose: Changes the command instruction prefix from
the tilde to another ASCII character.
Default: ~ (ASCII 126)
Change Y-pos
Purpose: Skid compensation for long labels. All fields will
move the specified percentage from their
absolute position. Interval value is -5.0% to
+5.0%.
To Next Page
Loading...
