Intermec EasyCoder PD41 Programmer's Guide

ZSim Programmer’s Guide 27
Factory Defaults
Purpose: Sets all of the ZSim program values back to the
default settings.
Feed Action
Purpose: Sets the feed action that occurs at Start Up and
When Head Down. Choices include No Media
Feed, Feed to Web, Media Sensor Calibration,
and Set Label Length.
Default: Feed to Web
Input Port
Purpose: Sets the type of input port you are using on your
printer. Valid values are Parallel, USB, or
Network.
Default: Network
Label Length
Purpose: Specifies the length of the labels in inches or
millimeters.
Label Width
Purpose: Specifies the width of the label in millimeters or
inches. Proper width prevents printing outside
of the printable area, which may harm the
printhead.
Note: You can only set the Label Length if the
Media Type is set to Continuous.
Default: Full width of printhead
Printer Model Default Printhead Width
PF2i 56 mm (2.2 in)
PF4i, PM4i 104 mm (4.1 in)
PX4i 112 mm (4.5 in)
PX6i 166 mm (6.6 in)
PD41 104 mm (4.1 in)
PB50 104 mm (4.1 in)

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g