Chapter 2 — Configuring Network Settings
IF30 Fixed Reader User’s Manual 25
To configure Ethernet settings
1 From the menu, click Ethernet. The Ethernet screen appears.
2 Configure the Ethernet settings. For help, see the next table.
If you need to configure DNS/Network Services settings, such
as DNS addresses or suffixes, or a SYSLOG destination, see
“Configuring Network Services” on page 28.
3 Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes,
and then click Save Change and Reboot. For help, see
“Saving Configuration Changes” on page 15.
Note: Different settings appear in this screen depending on
the current DHCP mode for the IF30.
To Next Page
Loading...
