Intermec IF30

Chapter 2 — Configuring Network Settings
IF30 Fixed Reader User’s Manual 27
Enabling IPv6
1 To enable IPv6 for your Ethernet connection, in the menu
click Ethernet > IPv6 Configuration.
2 Check the check box to enable IPv6, or uncheck the check
box to disable IPv6.
3 Click Submit Changes to save your changes. The IPv6
Configuration screen appears.
4 If you want to enable IPv6 autoconfiguration, click Enable
Autoconfiguration and continue with Step 5.
If you do not want to enable IPv6 autoconfiguration:
a Click Submit Changes. The screen refreshes with a list of
IPv6 configuration settings.
b Configure IPv6 settings. For help, see the next table.
5 Click Submit Changes. To activate your changes, from the
menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help,“Saving Configuration
Changes” on page 15.
IPv6 Settings Descriptions
Parameter Description
IPv6 Address A unique 128-bit IPv6 address.
IPv5 Subnet Mask The IPv6 subnet mask. Range is 1 to 128 bits.
IPv6 Router
(Gateway)
A unique 128-bit address for an IPv6 router.