Intermec IF30

Chapter 2 — Configuring Network Settings
IF30 Fixed Reader User’s Manual 35
5 For each password server, enter the IP address or the DNS
name, enter the shared secret key and port number.
6 Configure the password server database. For help, see the
documentation that came with your server.
Changing the Default Login
If you are not using a password server to authorize user logins,
Intermec recommends that you change the default user name and
password and create a read-only password.
To set up logins
1 From the main menu, click Security > Passwords. The
Passwords screen appears.
2 Clear the Use RADIUS for Login Authorization check box.
3 Click Submit Changes to save your changes.
4 Configure the parameters. For help, see the next table.
5 Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes,
and then click Save Changes and Reboot.
For help, see “Saving Configuration Changes” on page 15.
Note: If you enter more than one password server, the other
password servers act as backup servers. The IF30 uses the first
password server (starting with Server 1) whose IP address/
DNS name and secret key are the same as the one in the list.