Goodrive270 series VFD for fan and pump Safety precautions
-2-
Read
Read the operation manual before
Note
Note
Actions taken to ensure proper
Note
1.4 Safety guidelines
Only trained and qualified professionals are allowed to carry out related
operations.
Do not perform wiring, inspection or component replacement when power
supply is applied. Ensure all the input power supplies have been disconnected
before wiring or inspection, and wait for at least the time designated on the
VFD or until the DC bus voltage is less than 36V. The minimum waiting time is
listed in the following.
Do not refit the VFD unless authorized; otherwise fire, electric shock or other
The base may become hot when the machine is running. Do not touch.
Otherwise, you may get burnt.
The electrical parts and components inside the VFD are electrostatic sensitive.
Take measurements to prevent electrostatic discharge when performing
1.4.1 Delivery and installation
Do not install the VFD on inflammables. In addition, prevent the VFD from
contacting or adhering to inflammables.
Connect the optional braking parts (such as braking resistors, braking units
or feedback units) according to the wiring diagrams.
Do not run the VFD if it is damaged or incomplete.
Do not contact the VFD with damp objects or body parts. Otherwise,
electric shock may result.
Do not push the VFD sidewards during moving.
Prevent the VFD from tipping sidewards.
Note:
Select appropriate tools for VFD delivery and installation to ensure the safe and proper running
To Next Page
Loading...
Need help?
General
