Need help?Do you have a question about the INVT GD270-030-4 and is the answer not in the manual?
General| Power | 30kW |
|---|---|
| Rated Power | 30kW |
| Rated Current | 60A |
| Protection Level | IP20 |
| Applicable Motor Power | 30kW |
| Cooling Method | Air cooling |
Defines safety terms like Danger, Warning, and Note for proper equipment operation.
Highlights conditions that can cause severe injury or death and advises on prevention.
Provides definitions for safety terms like Danger, Warning, and Note.
Lists warning symbols and their meanings to prevent dangers.
Provides essential guidelines for safe operation, installation, and maintenance.
Guides through the essential commissioning steps before VFD use.
Explains the fundamental working principles of the VFD.
Details the technical specifications of the VFD.
Provides the electrical ratings for different VFD models.
Covers aspects of mechanical installation, including environment and mounting.
Details the main circuit wiring diagrams and procedures.
Explains the wiring diagrams and procedures for the control circuit.
Describes protective measures for VFD wiring against short circuits and overloads.
Explains the VFD keypad components and their functions.
Explains how to display parameters and status on the keypad.
Describes how to view fault alarms and indicators.
Guides on how to enter and edit function codes and parameters.
Provides step-by-step procedures for operating the VFD.
Details how to modify function codes through the VFD menu.
Explains how to set and manage the VFD user password.
Outlines the standard procedure for VFD commissioning.
Explains the vector control technology for driving motors.
Details the space voltage vector control mode and V/F curves.
Explains the VFD's torque control capabilities and limitations.
Guides on setting and autotuning motor parameters for optimal performance.
Describes the different start/stop modes and logic diagrams.
Explains various frequency reference modes and their settings.
Details the configuration of analog input terminals AI1, AI2, and HDIA.
Explains the configuration of analog output terminals AO0 and AO1.
Describes the functions of programmable digital input terminals.
Explains the configuration of relay and open collector output terminals.
Details the VFD's built-in Simple PLC function for multi-step control.
Explains how to set up and use multi-step speed running.
Provides an introduction to PID control principles and methods.
Details the proportional gain (Kp) parameter for PID control.
Explains the integral time (Ti) parameter for PID control.
Provides methods for fine-tuning PID parameters to optimize performance.
Provides information on how to handle VFD faults.
Details the organization and content of the function parameter tables.
Explains how VFD alarms and faults are indicated.
Describes methods for resetting VFD faults.
Provides a systematic approach to diagnosing and resolving VFD faults.
Lists common faults, their causes, and corresponding solutions.
Troubleshooting steps for when the motor does not operate.
Details the RTU command codes for VFD communication.
Lists common communication faults and their possible causes.
To Next Page
