nano3G AP Installation Manual nano3G AP Hardware Installation
N3G_INST_300 v8.1 for N3G_2.0.5 © ip.access Limited 2011 Page 61
7) Plug in the required cables. Either:
• Plug an Ethernet cable from the POE+ injector or POE+ switch into LAN1
or
• Plug an Ethernet cable from a switch/gateway (no POE+) into LAN1 and an
optional power supply into the +12V DC input
Note: Do not connect an Ethernet cable to LAN2. This will have no effect.
8) To refit the lower cover, slide it onto the tabs on the main cover until it snaps into
place.
To Next Page
Loading...