19
Programming mode 4
Programming
To open the " programming mode " , see 2 division in modes.
The selection can often be done by changing the order on the display if necessary with " NO "
(Bv. " no HECo " and after pressing " NO ": " HECo " ), and confirming this with " ENTER ".
During programming, it is possible to return step by step by pressing " STOP " ( stop-key ).
ProG (blinking) = Programming
Press " ENTER "
ProG (( = the Program number that has to be programmed
Enter the desired program number with " X,X ".
On the program number display, the program number is displayed. In order to select a program number above
9, the number should be formed with a combination of keys.
Press " ENTER " again.
The following step depends on the selection during " pre-programming ".
- With " no Coin " ( without coin switch ): change to " ((id (( ".
- With " Coin " ( with coin switch ): change to " Coin ".
Coin = Desired amount to start the washing program
Press " ENTER " and enter the amount with " X,X,X,X " .
Transpose the decimal point by pressing " START " .
Press " ENTER " again.
Press " STOP " to return to " ProG (( " in order to change another program price.
By pressing " STOP " once more, you can proceed immediately with " StArt ". In this way the amount can
be changed, without having to run through the entire program.
(( id (( = " Program number " and " program part number ".
The first XX represent the program number entered at " ProG ".
The second XX represent the " program part number ".
Example:
" 02id 03 " represents program 2, program part 3.
A program part is a part of a program ( pre washing, main wash cycle, rinsing etc. ) and is ended by a water
discharge in each case. In order to obtain a full wash cycle, several program parts should be entered
consecutively. ( max 99 per wash cycle ).
Enter a program part number with " X,X " and press " ENTER ".
If during programming, there is insufficient space in the " RAM memory " , the error message
" RaM full " will appear.
(( CYti = Cycle time
This is the duration of the washing time in this program part ( XX) ( without taken into account the temperature
and level control )
From now on " XX " stands for the program part number that has been entered.
Press " ENTER ".
t XX.XX = Time (Washing time in minutes and seconds)
Enter the time with " X,X " ( 0 to 60 minutes ) and press " ENTER ".
If " 0 " is entered, the program will proceed with " SPin " (of " no SPin ").
(( rotE = Rotation (Dwell - and washing movement times)
Press " ENTER ".
To Next Page
Loading...