37
Copying mode 5
Copying mode
To go to the " copying mode ", see 2 Division in modes.
The PC40 programmer is fitted with 10 fixed standard programs ( 40 to 49 ). These programs can be executed
directly.
At these locations however, it is impossible to change them. If you want to change them, or use them as the basis
of another program, you need to copy them first to a new program number between 0 and 39.
( see further ).
.Other already self programmed programs can also be copied to another number ( between 0 and 39 )in the same
way and then be used as a basis for other programs. In this way, you can save a lot of time when creating programs
that are much alike.
CoPY PrG = Copy program
To confirm, press " ENTER ".
To cancel, press any key ( transition to " StArt")
SourCE.(( = program to copy
With " X,X " , enter the program number and confirm with " ENTER ".
dESt.)) = Destination (destination of the copied program)
With " Y,Y ", enter a program number and confirm with " ENTER ".
((--)) = Confirmation of copy
To confirm: press " ENTER " ( transition to " StArt ")
To cancel: press any key ( transition to " StArt")
If there should be insufficient space in the RAM- memory, the error message " Ramfull " will appear.
Standard programs
On the pages at the back of the manual, you’ll find the composition of the standard programs according to
the different machine types.
To Next Page
Loading...