33
Programming mode 4
FrEE%((( = the maximum number program parts to program.
You can program 400 program parts at the most .
Press " ENTER ".
End = end of a program part.
Press "NO " to proceed with the next program part ( transfer to
"
((.id ))
"). )) stands for the following program part number.
Press " ENTER " to set the end of the program.
tu (((= Tumble (untwining)
This is being executed in a washing rhythm of 60 secs of action and 9 secs of stop time. The lowest speed that
occurs in this program is being used ( on frequency controlled machines ).
With " X, X, X ", enter the tumble time ( 30 to 999 secs ) and press " ENTER ".
If no untwining is needed, you can enter 0. A dwell time of 1 minute is then performed.
ALArm(((
Here is where you can activate the alarm signal.
With " X,X,X ", enter the time ( 0 to 250 secs ) during which you want to hear the alarm.
This option is only displayed when selected in pre- program (see "ALARM").
If " 999 " was entered, the alarm will remain activated until the door is opened.
Data((((
At the end of the programming, the new " checksum " is displayed ‘ during a couple of seconds, then you proceed
with " StArt " .
To Next Page
Loading...