27
´
´
´
´
Programming mode 4
The next step depends on the selection during " pre-programming ".
- Without " Add "( help program), transition to " SPin " (or " no SPin ").
- With " Add " ( help program ), transition to " Add " (or " no Add ").
Add = Additional program ( program extension )
When no program extension is desired, select " no Add " and press " ENTER " (transition to
" SPin").
If a program extension is desired , select " Add " and press " ENTER ".
With "NO" switched off select: " Cool ", " StoP ", " STOP ((( ", " SoAH ((( ", or once more
" no Add " and press " ENTER " to confirm your selection.
Cool = Cool-down
Cd'& (( = degree of temperature drop to the highest cool-down temperature
Enter the degrees of temperature drop at " X,X " (1 to 99 °/minute ) and press " ENTER ".
Cdu (( = highest cool-down temperature
Witht " X,X " enter the temperature ( 30 to 85 ) and press " ENTER ".
Cdn& (( = degree of temperature drop to the lowest cool-down temperature
With " X,X " enter the degree of temperature drop ( 1 to 99 °/ minute ) and press " ENTER ".
Cdn (( = lowest cool-down temperature
With " X,X " enter the temperature ( 30 to 85 and automatically limited to the value set at
" Cdu (( ") and press " ENTER ".
StoP = Stop
In the " operating mode " , the program will stop here, so f.ex. extra soap could be added manually ( the
water remains in the bath ). See operating mode: " programmed stop "
A " stop time " up to 999 minutes can be entered. After this stop time has expired, the program will
automatically restart.
StoP (((
With " X,X,X " enter the stop time ( 0 to 999 minutes ) and press "E".
If "0 " was entered, the program will be stopped until "START " is pressed.
SoAk = Soak
In the ‘ operating mode, the program will stop here, the level will be brought to " 25 " and every 3 minutes,
a left - right movement will be performed ( temperature will remain constant ). See operating mode :
" soak ".
You can enter a " soaking time " from up to 999 minutes. After this soaking time is up, the program will
automatically restart.
SoAk (((
With " X,X,X " you can enter the soaking time ( 0 to 999 minutes ) and press " E ".
If " 0 " has been entered, the program will be stopped until " START " is pressed..
ALArM (((
In the beginning of this soaking time you can activate the alarm signal.
With " X,X,X " you can enter the time ( 0 to 250 secs ) during which you want to here the signal.
This option can only be displayed if the pre-program is selected ( see "ALARM").
If " 999 " was entered, the alarm will be active during the complete soaking time!
no Add = No additional ( no program extension )
To Next Page
Loading...