42
Operating mode 6
Adding soap ( not on machines with coins
By pressing first button “3” and then the “+” button, “SO(t((” is indicated. By keeping one of the buttons from
“1” to “9” pressed then, soap is added through this entry. With button “0”, “-” -+”, soap can be added through entry
10 till 12. While pressing, the selected soap entry and time when the soap has been added are indicated.
This function does not operate during the first 3 minutes of the program.
Error indications
When there has been a technical failure during a program, " A( " or "" F( "” will be indicated at the end instead of
" P(( End ".
" A4 ": the filling time was longer than 15 minutes.
" A5 " : the requested temperature was not achieved after 60 minutes of heating.
" F6 " : the doorlock was unbolted.
" A7 " : there is still water in the tub at the end of the program (door cannot be opened).
" A8 " : the temperatur sensor was not operating.
" A9 " : the heat motor security was switched on during the program ( not for frequency controlled machines).
" Ac " : the water was not evacuated after 3 minutes : there was no further heating;
" Ad " : no rpm were measured during the spin (only for frequency controlled machines).
" AH " : the spin was not executed (max. number of tilts was exceeded.
These indications disappear after opening the door.
Certain error indications are directly shown and prevent the start of the cycle or stop the cycle.
" A2 " : an unknown program was chosen.
" F5 " : the door was opened during the program.
" Ab " : water level has still been detected at the start of the program.
" F6 " : the doorlock was unbolted during the program.
" FA " : the tilt switch is blokked.
These error indications disappear when the error is repaired.
To Next Page
Loading...