35
´
´
Inserting a program part.
Press " START ".
XX. inS = Insert
Press " ENTER ".
The program part " XX " is advanced with one position. " ((id (( " reappears on the display. This
program part can now be re-entered.
Example:
Program " 01 " with 4 program parts (01,02,03,04)
Between 02 and 03, one program part has to be inserted.
Select " 01id 03 " and press " START ". reappears on the display " 03ins ". Press " ENTER " .
" 01id 03 " reappears. Program part " 03 " should now be re-entered. The previous part " 03 " has moved
on to " 04 " , and " 04 " has moved on to " 05 " .
If there should be insufficient space in the Ram memory, the error message " Ram full " will appear.
Deleting a program part
Press " STOP ".
(( del (blinking) = Delete
Press " ENTER ".
The program part " XX " is being deleted. The following program parts are moved back with one position.
Example:
Program " 01 " with 4 program parts (01,02,03,04,)
Part 02 has to be deleted.
Select " 01id 02 " and press " STOP ". On the display appears " 02 del ". Press " ENTER " Nu
" 01id02 " reappears. This used to be program part " 03 ".
Program part 04 has been moved back to 03.
Program tables
Programming mode 4
Inserting and deleting a program part
Start the programming procedure till " ((id (( ".
The table on the following pages shows how the programmed data have been saved.
Copy the blank tables on the pages for as many times as there are programs to be set. Fill them in and save
them carefully.
To Next Page
Loading...