9
Pre-programming mode 3
Pre-programming
To open the "pre-programming mode": see 2. Division in modes.
In most case, the selection is done by changing the order on the display if necessary by " NO " ( ex. " no FC
" and after pressing " NO " : " FC " ) and confirming this with " ENTER ".
During pre-programming, it is possible to return step by step by pressing ‘0’ ( stop-key ).
PrE = Pre-program (altering the " Pre-program " )
Press " ENTER "
HF = Machine type HF, WE 245/304, or WE of the " washer extractors "
FC = Frequency controlled ( with frequency controlled motor )
Coin = Machine with coin switch
With " X,X,X " enter the value of the coin switch with the highest value.
Transpose the decimal point by pressing " START ".
By pressing " ENTER ", you can proceed with the other coin switches and set them accordingly.
LECo = Level control (water level control )
Temporarily stopping the program until the correct water level is reached.
LE.Pct= Level Procent
Here you can enter the water level as a percentage in proportion to the maximum.
SE-i = Select inlet ( Selection of the water inlet valves ).
To Next Page
Loading...