IPSO PS40 - Spin Cycle Configuration; Drain Valve 1 Setup; High Spinning Time

29
Programming mode 4
SPin = Spinning ( extraction )
If spinning is desired, select " SPin " and press " ENTER ".
If no spinning is desired, select " no SPin " and press " ENTER ". (transition to " dO "," d1 " of " d2
".........) .
The next step is dependent upon the type of machine:
With frequency controlled motor
Without frequency controlled motor
SPit (( = Spin time ( duration of spinning )
With " X " enter the duration of the spinning
( 1 to 15 minutes ) and press " ENTER ".
SP ((( = Speed (spinning speed)
With " X,X,X,X " enter the number of revolutions
of low spinning ( 250 to 1000 revs / min ) and
press " ENTER ".
On machines with drum diameter higher as
850 mm, this value is limited to 800.
dI = Drain 1 (drain valve 1)
Select " d1" , " d2 "," rd1" of "rd2" with
" NO" " and confirm with " ENTER ".
SPI- ( = Low spin time
With " X " enter the duration of low spinning
( 1 to 9 minutes ) and press " ENTER ".
dI = Drain 1 ( drain valve 1 )
Select " d1" of " d2 ",or " NO" " and confirm with
" ENTER ".
The number of drain valves from which you
can choose, is dependent upon the setting of
the pre-program.
The number of drain valves of which you can
choose, is dependent upon the settings of the
pre-program.
The next step depends upon the type of machine:
- Type WE: transfer to " XX. dEti ".
- Type HF, WE/4 : transfer to " SP2- ( ".
SP2- ((= Time of high spinning
With " X " enter the duration of high spinning
( max 15 minutes ) and press " ENTER ". ( if no
high spinning is desired, enter " 0 " )
(( dEti = Delay time (clearance time after
spinning )
Press " ENTER ".
td ((( = time delay ( clearance time)
With " X,X,X ", enter the time and press " ENTER ".
Time to enter:
30 to 180 secs after low spinning.
60 to 180 secs after high spinning.
(( dEti = Delay time ( clearance after spinning )
Press " ENTER ".
td ((( = time delay (clearance time)
With " X,X,X " enter the time and press " ENTER ".
Time to enter:
30 to 180 secs after spinning below
500 revs /min
60 to 180 secs after spinning above
500 revs / min