23
Programming mode 4
HECo = Heating control
If no heating control is wanted, select " no HECo " and press " ENTER ".
If heating control is desired, select " HECo " and press " ENTER ".
If " no HECo " is selected, there will be a transfer to " (( SE-i ".
t
XX = Time (duration of temperature control)
With " X,X " enter the time at which the control should be performed ( value between 0 and the washing time
entered at " (( CYTi " ) and press " ENTER ".
GEntlE = converting the movement and dwell time (set at " A XX " and " S XX ") during temperature
control.
" (( SE-i ". = Select inlet ( select water inlet valves )
Press " ENTER ".
i2 = Inlet 2 (inlet valve 2) (HF-WE-WE/4) or i1 = Inlet 1 (inlet valve 1) (HFP-machine)
With " NO " select if an inlet valve should be selected or not.
Press " ENTER " to continue with the next inlet valve.
To save space, not all valves have been drawn. The action is the same for each one of them.
You can find the function of the valves in chapter 3.
If , by mistake , you selected the wrong inlet valve , and the temperature should rise above the
" $C XX " set, cold water will automatically flow through inlet valve " i2 "
(HF-WE-WE/4) or " i7 " (HFP) for safety.
The following step depends on the selection made at " pre-program "
- without " SoAP " ( liquid soap supply ) : transfer to " (( SE L ".
- with " SoAP " ( liquid soap supply ) : transfer to " SoAP " (or " no SoAP ").
ir3 en CP can only be selected on machines with frequency control.
To Next Page
Loading...