21
´
´
´
Programming mode 4
A (( = Action time (movement time)
Enter the movement time with " X,X " (0 tot 60 seconden ).
When the motor is frequency controlled, a digit will appear after the decimal point and the time can be set
accurate to 0.1 sec.
When " 0 " seconds is entered ( cycle without movement of the drum ), the following step
(" S XX " ) is skipped.
Press "E ".
S
(( = Stop time (dwell time)
Enter the dwell time with " X,X " (1 tot 60 seconds ).
When the motor is frequency controlled, a digit will appear after the decimal point and the time can be set
accurate to 0.1 sec.( Minimum 0.5 sec ).
Press "E ".
The next step depends on the selection during the " pre-programming ".
- Without " FC " frequency controlled motor ): change to " XX. tEMP ".
- With " FC " ( frequency controlled motor ): change to " SP XX ".
SP (( = Speed
Enter the revolutions per minute of the washing movement with " X,X " (10 to 50 revs/min)
Press " ENTER ".
(( tEMP = Temperature (of the bath)
Press " ENTER ".
$C (( = Temperature (Or " $F (( " °C or °F according to your selection in pre-programming ).
Enter with " X,X " the temperature ( maximum 95 °C) and press " ENTER ".
In case of cold bath, enter " 0 ". Proceed with " XX. SE-i " immediately.
The following step depends on the selection made in " pre program " during " bij " HEAt-SYS ".
If " HEAt-Mod " was selected , you can now make a selection with " NO " switched off:
HEAt
( heating without modulation ) transition to " HECo " of " (( SE-i ".
HEAt-Mod ( modulation with supplementary heating ) transition to " HECo " or " (( SE-i ".
Mod ( modulation without supplementary heating ) transition to " (( SE-i ".
Press " ENTER ".
If " HEAt " was selected, there will be an immediate transition to " HECo " or " (( SE-i ".
If " Mod " was selected, there will be an immediate transition to " (( SE-i ".
To Next Page
Loading...