SAFETY
11
(7) Use ramps with the same or better specifications
mentioned below. When the machine is equipped
with attachments other than those included in the
specifications mentioned below, ask your Iseki
dealer for advice.
Specifications of the ramps
・
Length:
more than 4 times the height of the platform of
the truck
・
Width (effective width): more than 35 cm
・
Capacity (one ramp): more than 1700 kg
・
Ramps should have anti-skid surfaces
(8) Hook the ramps securely on the platform of the
tractor with the top of the ramp level with the
platform.
(9) Always prepare for even the worst, by never al-
lowing other persons near the tractor.
(10) Drive the tractor carefully at the moment the trac-
tor moves from the ramps onto the platform, for it
changes angle abruptly.
■
DURING OPERATION
(1) During operation, never allow other persons in
the vicinity of the tractor, because the tractor itself
or flung pieces may cause injury.
(2) Pay attention to safety around the tractor to avoid
injury to bystanders or damage to property.
Especially when operating with other persons,
use the horn to warn them.
(3) When crossing a ditch or a levee or when pass-
ing through soft land, drive the tractor slowly and
straight so that it does not slip or turn over.
(4) Do not touch dangerous parts such as rotating
parts, moving pars, hot parts (muffler, radiator, or
engine, etc.), or electric parts (battery terminals and
other live parts), or you may be injured seriously.
(5) If you use a trailer, use a proper one which suits
your tractor. Using an improper trailer may cause
serious accidents. Never attempt to haul beyond
the tractor’s capacity. If you have a question,
please consult your Iseki dealer.
Follow strictly the instructions outlined in the
operator’s manual of the mounted or trailed ma-
chinery or trailer, and not to operate the combina-
tion tractor – machine or tractor – trailer unless all
instructions have been followed.
more than 4 times
the height of the platform (h)
FIG. 1-16
FIG. 1-17
FIG. 1-18
FIG. 1-19
To Next Page
