TXG237
26
Indicator Light Strip
FIG. 3-4: Indicator light strip contains several warn-
ing lights to monitor certain functions. Currently used
positions (from left to right) are:
Battery Charge (1) - Lights up when main switch is
turned “ON” and will go out after engine starts, to indi-
cate battery is being charged.
Engine Oil Pressure (2) - Lights up if engine oil pres-
sure is low. If the light comes on while engine is run-
ning, shut off the engine immediately and investigate
the cause.
Coolant Temperature (3) - Lights up when the engine
is overheated.
NOTE: When any of the indicator lights above stays
lit, stop the engine immediately and consult
your dealer.
Turn Indicator Lamps (4) - Blinks when the turn sig-
nal is activated.
Glow Monitor (5) - Lights up when key is turned to
“GLOW” position. (Light does not turn off if glow is ready.)
Main (high) beam (6) - Lights up when the head-
lamps in the front grille are selected to the high beam
position by the lamp switch.
Trailer Lamps (7) - Lights up when the trailer is attached
and the coupler is connected with the 7-pin socket.
4WD Monitor (8) - Lights up when “4WD” is engaged.
Parking Brake warning lamp (9) - Lights up when
parking brake is pulled up.
Power Take-off (PTO) - (10) Lights up if PTO control
switch is moved to engage PTO clutch pack (PTO
operating.)
Hour Meter
FIG. 3-5: Hour meter indicates engine and tractor use
to assist in maintenance intervals. The extreme right
digit indicates 1/10 h increments.
FIG. 3-4
FIG. 3-5
To Next Page
