System Commands
Copyright © Itech Electronic Co., Ltd. 16
Command syntax
STATus:QUEStionable:NTRansition <NR1>
Parameters
0~65535
Example
STATus:QUEStionable:NTRansition 128
Query syntax
STATus:QUEStionable:NTRansition?
STATus:QUEStionable:PTRansition
This command set the value of the Questionable PTR (Positive-Transition)
register. The register serve as polarity filters between the Questionable
Condition and Questionable Event registers to cause the following actions.
When a bit of Questionable PTR register is set to 1, then a 1-to-0 transition of
the corresponding bit of the Questionable Condition register causes that bit in
the Questionable Event register to be set.
Command syntax
STATus:QUEStionable:PTRansition <NR1>
Parameters
0~65535
Example
STATus:QUEStionable:PTRansition 128
Query syntax
STATus:QUEStionable:PTRansition?
STATus:OPERation[:EVENt]?
This command can read the parameter from operation event register.
After executing this order, operation event register is reset.
Query syntax
STATus:OPERation[:EVENt]?
Parameters
None
To Next Page
Loading...
